Sunus Suntek ATX Power Supplies

|| Output Requirements || Specifications || Features || Remote ON/OFF Control ||

Specifications
Input Characteristics:

Input Voltage: 90 - 132 VAC or 180 - 264 VAC switchable
Frequency: 47Hz - 63Hz
Input Current:
Inrush Current: at 25^o C ambient cold start.

With +3.3V output option and +5V remote control (Standby ON/OFF control)
Output over voltage protection and short circuit protection on all output
High efficiency, low noise and ripple.
100% burn-in & Hi-pot tested.
Overload protection: 110% - 140% Max.

Remote ON/OFF Control
This TTl compatible signal (active low) is used to switch ON/OFF the main outputs

As power supply-ON: TTL is Low (DC outputs are to be enabled)
As power supply-OFF: TTL is HIGH/OPEN (DC outputs are to be disabled)

Regulation, Ripple & Noise

	LOAD REGULATION	CROSS REGULATION	LINE REGULATION	RIPPLE & NOISE
+3.3V	+(-) 5%	+(-) 5%	+(-) 1%	80mV P-P
+5V	+(-) 5%	+(-) 5%	+(-) 1%	60mV P-P
-5V	+(-) 5%	+(-) 5%	+(-) 1%	60mV P-P
+12V	+(-) 5%	+(-) 5%	+(-) 2%	100mV P-P
-12V	+(-) 10%	+(-) 10%	+(-) 2%	80mV P-P
+5Vsb	+(-) 5%	+(-) 5%	+(-) 1%	60mV P-P

Dimension: 150(L) x 140(W) x 115(H) / mm: Version A
150(L) x 140(W) x 86(H) / mm: Version B & C

* All above Power Supply are ATX version 2.01
* All specifications subject to change without notice.
* Power Switches are optional.

SUNUS SUNTEK

Headquarters
46045 Warm Springs Blvd, Fremont, CA 94539
Tel: 510-824-6868 Fax: 510-824-6869
info@suntekgroup.com

You are the 38,563rd visitor.